NAS System
User’s Manual
15
2.3.2 Rear View
NOTE: For maximum performance, we recommend that you select the
second PCIe bus(x8 connector) for installing other HBA (10G LAN,
SAS, FC). Refer to the motherboard documentation to obtain a block
diagram of all available PCI buses. This diagram will help you
determine which connectors belong to which buses. Contact your
dealer or sales representative for additional assistance.
1.
SAS Expansion Port – For connecting to SAS Expansion Chassis.
2.
Power On/Off Switch – Use this switch to power on the system.
3.
LAN Ports – The system comes with three 1Gigabit Ethernet ports LAN0, LAN1
and LAN2.
4.
RS232 Port (Phone-Jack) – This is used for upgrading the firmware of JBOD
Controller SAS Expander board.
5.
VGA Port – Use this to connect a VGA monitor.
6.
USB 2.0 ports – Four USB ports are located at the rear of the system.
7.
COM1 and COM2 Serial Ports – The system has one two serial ports COM1 and
COM2.
8.
Mute – Use the mute button to stop the power supply buzzer alarm.
9.
AC Power Input Socket – Use this to plug in the power cable connected from
power source.
10.
Power Supply A, B – Two power supplies PSU-A and PSU-B are located at the
rear of the NAS system.
