17
Be careful when inserting the cable. Forcing or breaking this connection by inserting the wrong cable or
abusing the connector by forcing the plug is not covered under warranty. When plugged into the onboard
USB charger, your battery will begin charging. You can continue using the device while it's plugged in but
the USB cable will not supply enough power to act as a pass-through, using your battery energy when
you vape. When the device is idle, it will continue charging the cell inside. We have tested a number of
USB battery packs and these all work great for charging your device while on the road. You can get these
items from your local electronic store or from Amazon.
插入电缆线时要注意，采用错误的电缆或粗暴地插入导致的接口损坏不在保修范围内。当内置的
USB
充电
器接通时，电池开始充电。充电时，你还可以继续使用该设备，但是这是由电池供电，
USB
电缆提供的电
量不够。没有使用设备的时候，它会继续充电。我们测试过很多
USB
充电宝，
它们都能够很方便地对您
的设备进行充电。您在当地的电子商店或亚马逊都购买得到。
Battery Life
电池寿命
When the battery is depleted, the battery icon on the screen will indicate that it's time to recharge. At this
time recharge the battery.
当电池耗尽时，屏幕上的电池图标会显示需要充电了。这时候进行充电。
Inserting a Battery
安装电池
The Radius was designed to easily charge the unit's battery by plugging a Micro USB cable on the side of
the unit. Should you need to replace the battery however, it can be easily serviced at home. On the
bottom of the unit, there are two thumb screws. Remove these two screws and the bottom plate can be
removed. Once the plate is removed you will have access to removing the battery and installing a new
cell. Note, there is a small metal tab that sits between the battery and the spring. Once the new battery is
installed, make sure this metal tab rests on the bottom of the battery, then position the bottom plate onto
the housing with the spring pressing on the metal tab. Install the two screws and you are ready to vape
with a new battery. This whole process takes less than 40 seconds. We've designed the Radius with a
metal plate that covers the bottom end of the battery to ensure you get the best possible battery
connection. This increases your run time and gives you optimum battery performance and longevity.
Radius
的设计方便用微
USB
给设备里的电池充电。但是如果需要更换电池，在家里就可以轻松的完成。
在设备的底部，有两个拇指螺钉。拆下这两个螺钉就可以取下底板。然后就可以取出电池，安装新电池。
请注意，在电池和弹簧之间有一块小金属片。新电池装好后，要确保这个金属片处于电池的底部，安装底
板时，要让它上面的弹簧压住这个金属片。拧上这两个螺钉，就可以重新使用了。整个过程花的时间不到
40
秒。我们在设计
Radius
时，在电池的底部增加了一块金属片以确保最好的电池接触。这会增加您的使
用时间，优化电池的性能和使用寿命。
When assembling the unit, do not over-tighten the screw. They should be snug, but not so tight that you
won’t be able to remove them when you need to replace the battery.
在装配设备时，不要过度拧紧有螺纹。它们之间的接触要适度，不要太紧，否则在换电池时就没办法拧开
了。
Questions? Problems?
疑问或设备故障？
