Protherm Gepard 23 MOV, Training Manual, Page: 32 / 68

- 32 -
T e c h n i c a l N o t e b o o k . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
T e c h n i c a l T r a i n i n g
The Installation and After-Sales menus by theme:
Parameter Code
read
only
Burner power
Maximum heating power d.00
Offset for minimum steppermotor position d.52
Offset for maximum steppermotor position d.53
Domestic hot water power (AS boiler) d.77
Time delays
Pump post flush time d.01
Anti short-cycle delay d.02
Anti short-cycle delay remaining d.67 x
Temperature
Tank temperature (if fitted with an NTC) d.04 x
Heating flow temperature setting d.09 x
Domestic Hot water max. temperature setting d.20
Solar circuit inlet temperature d.39 x
Heating output temperature d.40 x
Heating return temperature d.41 x
Outside temperature d.47 x
Max. Heating flow temperature setting. d.71
Pumps
Internal pump status d.10 x
Auxiliary pumps status d.11 x
Pump operation d.18
Pump speed d.19
Checking of input requests
Heating request by an ON/OFF thermostat d.16 x
Hot water preheating or tank reheating without
NTC or thermostat request.
d.21 x
Hot water request by thermostat, NTC or flow
detector, without preheating request.
d.22 x
Heating demand d.23 x
Tank reheating or preheating activated either by
the interface or by an e-bus thermostat
d.25 x
Night-time offset d.62
ECS preheating function d.66
eBus room thermostat detection d.90 x
Parameter Code
read
only
Regulation
Regulation type (outlet or return) d.17
Heating curve d.43
Heating curve base d.45
Fan
air pressure switch (for SE models) d.24 x
Fan speed setting d.33 x
Real fan rotation speed d.34 x
Minimum speed correction d50
Maximum speed correction d51
Accessories
Relay 1 function d.27
Relay 2 function d.28
Statistics
Average burner ignition time d64 x
Max. burner ignition time d65 x
Number of ignitions failed on the first attempt d68 x
Number of ignitions failed on the second attempt d69 x
Heating operating time d.80 x
Hot water operating time d.81 x
Number of burner ignitions in heating d.82 x
Number of burner ignitions in hot water d.83 x
Misc.
Filling loop mode (adjustable only for Panther) d.31
Position of 3-way valve d.35 x
Draw flow rate d.36 x
Ionisation check d.44 x
3-way valve forcing (AS) d.70
Product code setting d.93
Reinitialise fault list d.94
Program versions d.95 x
Return to factory settings d.96