11
12
4mm Bullet Connectors
plugging to power
supply directly
Using terminal
clip attaching to
car battery
LITHIUM POLYMER BALANCE CHARGE PROGRAM
CONNECTION DIAGRAM
CONNECTING THE CHARGER
The Prodigy 610 comes with male 4mm Bullet connectors attached to the power INPUT
cables. These cables are appropriate for attaching directly to most high-quality AC-DC
power supply units, such as ProTek R/C Super Pro 40 (13.8V, 40A). Also included are
large Terminal Clips with matching 4mm female bullet connectors, for attaching directly
to 12V car batteries. It is critically important that you use either a fully charged 13.8 car
battery or a high quality AC-DC power supply in the range of 11V~18V DC output, with
minimum current rating of 20A to insure reliable performance.
CONNECTING THE BATTERY
Important!
Before connecting a battery it is absolutely essential to check one last time
that you have set the parameters correctly. If the settings are incorrect, the battery may
be damaged, and could even burst into flames or explode. To avoid short-circuits between
the banana plugs, always connect the charge leads to the charger first, and only then to
the battery. Reverse the sequence when disconnecting the pack.
LITHIUM POLYMER BALANCE CHARGE PROGRAM
CONNECTION DIAGRAM
Balance socket:
The balance wire attached to the battery must be connected to the charger with the
black wire aligned with the negative marking. Take care to maintain correct polarity!
(Wiring diagram: see below.)
This diagram shows the correct way to connect your battery to the Prodigy 610 while
charging in the balance charge program mode only.
Failure to connect as shown in this diagram will damage this charger.
To avoid short circuit between the charge lead always connect the charge cable to
the charger first, then connect the battery. Reverse the sequence when disconnecting.
WARNING:
