17
18
CHARGING LITHIUM BATTERY IN THE BALANCE MODE
CHARGING LITHIUM BATTERY IN THE FAST CHARGE MODE
Charging lithium battery in the balance mode
This function is for balancing the voltage of Lithium-polymer battery cells while charging.
In the balance mode, the battery needs to have a balance lead to connect to the individual
balance port of the charger. And you need to connect the battery's power lead to the
output of charger. Charging in this mode is different from the normal modes, because the
built-in processor monitors voltage of individual cell and control input current fed into each
cell to equalized voltage of individual cell.
The left side of the first line shows the type of battery you
choose. The value on the left of the second line of the charger
is current user set, After setting the current and voltage, press
START/ENTER key for more than 3 seconds to start the
process.(charge current: 0.1-10.0A, voltage: 3.7-22.2V).
This displays the number of cells you set up and the processor
detects. “R” shows the number of cells detected by the charger
and “S” is the number of cells set by you at the previous screen.
If both numbers are identical you can start charging by press
START/ENTER button. If not, press BATT TYPE/STOP button
to go back to previous screen to carefully check the number of
cells of the battery pack before going ahead.
This screen shows the real-time status during charge process.
Press BATT TYPE/STOP key once to stop the charge process.
Charging lithium battery in the fast charge mode
The charging current is getting smaller as the process goes to the near end term of Lithium
battery charging. To finish charging process earlier, this program eliminate certain term of
CV process. Actually, the charging current will goes to 1/5 from the initial value to end the
process while the normal charging goes to 1/10 during CV term. The charging capacity may
be a bit smaller than normal charging but the process time will be reduced.
The value on the left side of the second lines sets the charge
current. The value on the right side of the second lines sets the
battery pack's voltage. After setting current and voltage, press
STAR/ENTER for more than 3 seconds to start the process.
This displays the number of cells you set up and the processor
detects. “R” shows the number of cells detected by the charger
and “S” is the number of cells set by you at the previous screen.
If both numbers are identical you can start charging by press
START/ENTER button. If not,press BATT TYPE/STOP button
to go back to previous screen to carefully check the number of
cells of the battery pack before going ahead.
This screen shows the real-time status during charge process.
Press BATT TYPE/STOP key once to stop the charge process.
