Protege PRT-CTRL, Installation Manual

Page: 23 / 36

21 Protégé System Controller Installation Manual
CONFIGURATION SWITCH
Introduction
The Protégé System Controller uses a 4 way dual in line dip switch located in the centre of the
PCB board. This switch is used to configure the boot up and power on settings for the
controller.
Configuration Switch
Each of the switch positions performs a different function. For normal operation all of the
switches should be in the off position.
Figure 24 - System Controller Configuration Switch
Switch Function
1 2 Power Up Boot Mode
OFF OFF Normal Operation
ON OFF BOOT Loader
OFF ON BIOS Utility
ON ON Reserved Do Not Set
3 BIOS Terminal Communication Mode
OFF TCP/IP Telnet/Teraterm/HyperTerminal (Port 9000)
ON Serial Network Interface.
This option uses the module network communication
port to configure the system. Use this option if ethernet
can not be used or the IP address is not configured.
4 System Default
OFF Normal Operation
ON Factory Default System Controller
System Default
The system controller can be set back to factory default using the following procedures. This
will reset ALL internal data and event information.
1. Power down the system controller by switching off all power and battery backup
connections.
2. Turn ON Configuration Dip Switch 4.
3. Power up the system controller by turning on the AC supply.
4. Turn OFF Configuration Dip Switch 4 once the system controller is indicating
normal status by flashing the green status indicator.
The system will now be defaulted with all programming and settings returned to factory
configuration.