Protege PRT-CTRL, Installation Manual

Page: 19 / 36

17 Protégé System Controller Installation Manual
Each zone input can use a different input configuration. To program a large number of zones
with a certain configuration use the Multiple Selection feature in the Protégé System
Management Suite application.
When using the No Resistor configuration, the Controller only monitors the opened and closed
state of the connected input device generating the alarm and seal conditions.
Figure 21 - No EOL Resistor Zone Configuration
Trouble Zone Inputs
Each Controller can monitor up to 64 local trouble zones. Trouble zones are used to monitor
the status of the Controller and in most cases not physically connected to an external zone.
For example, trouble zone CP001:03 is used to monitor the Controller’s backup battery
voltage and warn the Controller that the battery is disconnected or voltage is too low. This
can then be used to report a message to a monitoring station, remote computer, keypad or
siren.
The following table details the trouble zones that are configured in the system controller. The
trouble type and group define the trouble that is generated by the trouble zone when it is
activated.
Zone Number Description Type Group
CP001:01 Module Tamper System Tamper System
CP001:02 AC failure Power Fault General
CP001:03 Low Battery Power Fault General
CP001:04 Real Time Clock Not Set RTC/Clock Loss General
CP001:05 Service Report Test * *
CP001:06 Service Report Failure To
Communicate Reporting Failure General
CP001:07 Phone Line Fault Phone Line Lost General
CP001:08 Auxiliary Failure Power Fault General
CP001:09 Bell 1 Cut/Tamper Bell/PGM Fault General
CP001:10 Bell 2 Cut/Tamper Bell/PGM Fault General
CP001:11 Bell 1 Over Current Bell/PGM Fault General
CP001:12 Bell 2 Over Current Bell/PGM Fault General
CP001:13 Module Communication Module Loss System
CP001:14 Module Network Security Module Security System
CP001:15 Expansion Device Missing Hardware Fault System
CP001:16 Communication Port 1 Fault Hardware Fault System
CP001:17 Communication Port 2 Fault Hardware Fault System