22
Rev 1
Starting the Red Light session
The session will automaticall begin after the external timer delay time has expired. During
the preset delay time the session can be started by manually pressing the START button on
the external timer, thereby overriding the delay time.
If you are using the unit in stand-alone mode press START on the display, the maximum
session time will show in the display. Use the minus button to select the minutes based on
your skin type followed by the START button to then start your session.
If you do not override the delay time then you will have a few minutes to prepare yourself
for the session.
• Remove all clothes and jewelery
• Remove make-up and cosmetics
• Put on lotions( if applicable)
• Remove glasses, contacts can be worn under goggles.
• Put on protective goggles.
• Lay down in the unit facing up towards the display
• Close the device
• When the session is over do not push up on the acrylic but rather put your hand outside
the unit and push the canopy open.
If you are ready prior to the delay time being over you can override the delay by hitting the
START/STOP button on the timer.
Operation during the session
During the session the features can be used by pushing the buttons on the control panel.
You can push the feature you wish to use (i.e. the fan button followed by the increase
button or decrease button.
Note: 20 seconds after your last input the control display screen will go back to the session
time. You can change the features at any time by pushing the button of the feature you wish
to activate.
