Page 7 of 11
21
Push rubber infill down and slide 2 x M8 T-Nuts into each channel at an equal
distance from the ends of a pair of crossbars on the same side of the vehicle. The
6mm Alley key can be used to assist T-Nut installation into the channel.
Use the Awning Brackets to ensure T-Nuts align with holes on the Awning Brackets.
INSTALLATION OF SHADE AWNING PLUS RECOVERY TRACKS CARRIER MOUNTING
BRACKETS (PR3207) ON PRORACK S-WING AND INTERNATIONAL T-SLOT
CROSSBARS
22
Noting the orientation of the Awning Brackets as pictured, check that Awning will not
interfere with opening doors once fitted. If there is not enough clearance it may not
be possible to continue with this set-up option. If there is enough clearance, secure
a Recovery Tracks Carrier Mounting Bracket on top of each Awning Bracket to the M8
T-Nuts in the Crossbars by referring to Figure 7. Tighten to 4Nm with 6mm Allen Key
provided or a suitable torque wrench.
M8 Washer
Awning Bracket
M8 Spring Washer
M8 Socket Head
Capscrew 20mm
M8 T-Nut
Fig. 7
Mounting Bracket
23
Measure the distance of the centre of the holes in the Awning Brackets between each
crossbar.
24
Slide 2 x M6 Hex Bolts into the top channel and 2 x M6 Hex Bolts into the bottom
channel of the mounting extrusion on the rear of the awning.
Once all four bolts have been placed into the extrusion, use the measurement from
the previous step to position the bolts so that they align with the holes on the Awning
Brackets.
