Page 3 of 11
Referring to Figure 2, secure each M6 Hex Bolt to the Awning Brackets using 1 x M6
Washer and 1 x M6 Nylock Nut. Tighten all bolts to 4Nm with a 10mm Spanner or a
suitable Torque Wrench.
Fig. 2
M6 Washer
M6 Nylock Nut
M6 Hex Bolt
5
Your awning is now fitted and ready for use. Please read the Set Up instructions on
Page 9.
6
7
Push rubber infill down and slide 2 x M8 T-Nuts into each channel at an equal
distance from the ends of a pair of crossbars on the same side of the vehicle. The
6mm Alley key can be used to assist T-Nut installation into the channel.
Use the Awning Brackets to ensure T-Nuts align with holes on the Awning Brackets.
INSTALLING SHADE AWNING DIRECT TO PRORACK S-WING AND INTERNATIONAL
T-SLOT CROSSBARS
8
Noting the orientation of the Awning Brackets as pictured, check that Awning will not
interfere with opening doors once fitted. If there is not enough clearance use the
alternative orientation of the Awning Brackets. If there is enough clearance, secure
the 2 x Awning Brackets to the M8 T-Nuts in the Crossbars by referring to Figure 3.
Tighten to 4Nm with 6mm Allen Key provided or a suitable Torque Wrench.
Fig. 3
M8 Washer
Awning Bracket
M8 Spring Washer
M8 Socket Head
Capscrew 20mm
M8 T-Nut
M8 Washer
Alternative Awning Bracket Orientation
Note - Additional
washers not supplied
