PRONAR VMP-10, Manual, Page: 72 / 78

5.20
degree of fragmentation is the lowest and in position (C), the greatest. Adjusting blades
consists in taking following actions:
•
loosen screw joint (4) – figure ( 5.8A )
•
unscrew nut and dismantle joint (3) – figure ( 5.8A ),
•
set the blade in desired working position,
•
screw all joints (3) and (4) tight by applying appropriate force.
FIGURE 5.9A ADJUSTING CUTTING BLADES
(1) cutting blade, (A), (B), (C) position of blade, (D) rotation axis ob blade during adjusting
procedure
ATTENTION
Cutting blades are extremely sharp, thus you must exercise special care when adjusting
them.
During adjusting procedure, the blade rotates vs. Hole (D). Changing position in direction
marked with an arrow will decrease degree of feed fragmentation (from position (C) to
position (A)). Setting the blade in opposite direction (from (A) to (C)) will increase the degree
of feed fragmentation, but wear and tear of blades shall increase as well. Position (B) is set in
the factory and makes up the standard setting.
A
B
C
C
1
D