PRONAR VMP-10, Manual, Page: 41 / 78

4.3
braking system pipes (hydraulic and pneumatic) as well as hydraulic pipes of shutters
steering system connected, one ought to verify whether all systems work properly and check
whether there are no leakages in servomotors. At the end, one ought to actuate power take-
off shaft in tractor and confirm that the machine works properly. The tank must be empty at
that time.
ATTENTION
Before each start-up it is necessary to check whether there are no objects, nor living
beings inside the tank.
This action must be taken by two individuals, because operator of tractor must stay in the
cabin. If there are no abnormal sounds coming out of the tank and gear operation as well as
worm and telescopic-joint shaft operation is unquestionable, one may set to work. In case of
any abnormalities in operation, turn off power take-off in tractor immediately and find
damaged part. If there is no possibility to fix that imperfection or its fixing will result in loss of
warranty, it is necessary to contact with the seller or directly with the manufacturer of the
machine.
CAUTION
Non-observance of recommendations contained in this manual or improper start-up of
the feed car may be the cause of machine failure.
Technical condition of the machine before setting to work must not raise any doubts.
4.2 PREPARATION FOR NORMAL WORKING MODE
When preparing the car for normal operation, one must check:
•
condition of wheels and tyre pressure,
•
whether wheel screws and draught bar screws are screwed tight,
•
condition of other screw joints,
•
lighting and signalling system performance,
•
braking system performance,