PRONAR VMP-10, Manual, Page: 27 / 78

3.3
3.2 CHASSIS
The chassis of the feed car is built of assemblies marked in the Figure ( 3.1A ). Bottom frame
(1) is a welded element made of steel sections. The basic bearing elements are two frame
side members. In the middle of the element there are seats for attaching scales. The lighting
beam is attached to the closing profile located in the rear of the rear frame, and in front of the
lower frame, there are the draught bar (5) along with string (6), platform (8) and support (7).
Seats and clamps designed for fastening connectors of hydraulic and pneumatic piping when
the machine is in a halt state are screwed to the platform.
FIGURE 3.1A CHASSIS
(1) bottom frame, (2) carriageable axle, (3) lighting beam, (4) wheel, (5) draught bar, (6)
string, (7) support, (8) platform, (9) seats for hydraulic connectors, (10) pneumatic pipes
clamps
In the rear of the bottom frame there is a carriageable axle (2) that was made of square rod
ended with pins. On pins, on cone bearing, there are wheel hubs. Wheel hubs are equipped
1
2
3
4
5
6
7
8
10
9