PRONAR T130, Operator'S Manual

Page: 19 / 90

2.5
•
Use the hydraulic oil recommended by the Manufacturer. Never mix two types
of oil.
•
After changing the hydraulic oil, the used oil should be properly disposed of.
•
When working on the tyres, chocks or other objects without sharp edges should
be placed under the wheels of the sand spreader to prevent it from rolling.
•
Repair work on the wheels or tyres should be carried out by persons trained
and entitled to do so. This work should be carried out using appropriate tools.
•
After removing a wheel, always check how firmly the nuts are screwed in.
Individual checks should be made after the first use, after the first journey with a
load, after travelling 1000 km and then every 6 months. The above actions
should be repeated individually if a wheel has been removed from the wheel
axle.
•
In the event of work requiring the sand spreader to be raised, use properly
certified hydraulic or mechanical lifts for this purpose. After lifting the sand
spreader, stable and durable supports must also be used. Do NOT carry out
work under a machine, which has only been raised with the lift jack.
•
The sand spreader must not be supported using fragile elements (bricks or
concrete blocks).
•
Check the tyre pressure regularly. Owing to the large temperature differences in
winter, it is recommended that the air pressure be checked more often.
•
In the event of any fault or damage whatsoever, do not use the sand spreader
until the fault has been corrected. The sand spreader must not be used when
not in working order.
•
When operating the machine wear protective gloves and use the appropriate
tools.
•
Servicing and repair work should be carried out in line with the general
principles of workplace health and safety. In the event of injury, the wound must
be immediately cleaned and disinfected. In the event of more serious injuries,
seek a doctor's advice.