PRONAR T028KM, Operator'S Manual

Page: 91 / 101

SECTION 5 PRONAR T028KM PRONAR T028ML
5.29
and warning decals, identification plate, conduit connections, lubrication points,
leaf springs and drawbar shock absorber, etc. High pressure water jets may get
inside the machine and cause mechanical damage or corrosion.
•
For cleaning and maintenance of plastic coated surfaces it is recommended to
use clean water or special preparations designed for this purpose.
•
Do not apply organic solvents, preparations of unknown origin or other
substances, which may cause damage to lacquered, rubber or plastic surfaces. In
the event of doubt it is recommended to make a test on an unseen surface area.
•
Surfaces smeared with oil or grease should be cleaned by application of benzene
or other degreasing agents and then washed with clean water with added
detergent. Comply with recommendations of the Manufacturer of cleaning agents.
•
Detergents should be kept in original containers, optionally in replacement
containers, but very clearly marked. Preparations may not be stored in food and
drink containers.
•
Ensure cleanliness of elastic conduits and seals. The plastic from which these
elements are made may be susceptible to organic substances and some
detergents. As a result of long-term reaction of some substances, the ageing
process may be accelerated and risk of damage increased. Rubber elements
should be maintained with the aid of special preparations after previous thorough
washing.
DANGER
Carefully read the instructions for application of detergents and maintenance
preparations.
While washing with detergents wear appropriate protective clothing and
goggles protecting against splashing.
•
Observe environmental protection principles and wash trailer in a place designed
for this purpose.
•
Washing and drying the trailer must take place at temperatures above 0°C.
•
Leaf springs should be cleaned using a hard brush. The space between spring
leaves should be blown using compressed air.