PRONAR PWP900, Operator'S Manual, Page: 27 / 74

SECTION 2 PRONAR PWP900
2.7
•
The machine must not be used when not in working order.
•
Set the tedder in working position before starting the tedder's drive.
•
During tedding use the correct working position.
•
When tedding on the edges of streets, public roads, on stony ground there is a risk
that thrown out stones and foreign bodies may pose a risk to bystanders and other
vehicle passing by.
•
Before starting the tedder make sure that there are no bystanders (especially
children) or animals in the danger zone (the area with a radius of up to 50 m from
the tedder). The machine operator is obliged to ensure proper visibility of the
machine and the working area.
•
During tedder operation, do NOT exceed the PTO speed of 540 rpm. Do NOT
overload shaft and tedder and also engage the clutch suddenly. Before starting the
tedder drive, make certain that the PTO rotation direction is correct.
•
Do NOT leave the tractor cab, when the machine drive is engaged.
•
Do NOT stand within the rotary tedder's working zone.
•
Do NOT operate the rotary tedder while reversing. While reversing and during
turns, the tedder drive must be disengaged.
•
While tedding apply working speed recommendations.
2.1.7 OPERATION OF PTO SHAFT
•
While reversing and during turns, the PTO drive must be disengaged.
•
The machine may only be connected to the tractor by appropriately selected PTO
shaft recommended by the Manufacturer.
•
Adjust the length of PTO shaft to compatible tractor according to the Operator's
Manual of PTO shaft.
•
The PTO shaft has markings on the casing, indicating which end of the shaft shall
be connected to the tractor.
•
Never use a damaged PTO shaft, it may cause an accident. A damaged shaft
must be repaired or replaced.
•
Disconnect the drive shaft each time when it is not necessary to drive the
machine, or when the tractor and tedder are at an unsuitable angle to each other.