PROMULTIS Totem Focus, Instruction Manual

Page: 13 / 30

Basic Operations
11
Note: If the totem does not receive a displaying signal for a certain time, the totem goes into standby mode.
Plug the power cord into an AC Power outlet. Press Power Switch on the totem.
Now the totem is in standby mode. Wait a moment until the power indicator lights up, then press POWER to
turn on the totem. (Be sure to wait for a few seconds before pressing POWER button. If you promptly press
POWER button then the totem may not respond or act wrongly.)
Press button again to turn off the totem and put the totem in standby mode.
To cut off the power completely, press Power Switch on the totem.
1
2
3
Turning the totem on or off
Operating the Float menu
The first time installation
Connect to power source and turn on the totem, the below installation menu page will display on the totem.
Select desired menu
language, then press
START
and go to next page.
Select location and go to
next page.
1.Slide up from bottom of the screen center by two or more fingers to call .
Press and drag to any place of the screen.
2. Press to take 2 seconds to be activated in VGA/HDMI/DP/PC mode.
3.When displaying at USB interface, touch once at the lower part of the screen, the display
control menu will appear.
Call the Volume bar
Call the input source menu
Back to previous
Turn off the screen
Call the application history
Call the Home page (Android Interface)
Call the annotation