![background image](http://html.mh-extra.com/html/promise-technology/vess-a3340d/vess-a3340d_quick-start-manual_1617254019.webp)
m
AnAgement
P
Ath
-
network
connection
The Gigabit Ethernet RJ-45 ports on the rear panel for the network connection used
for device administrator. These ports must be physically and logically connected to the
subnet used by the system administrator. These ports are also used for
To establish the management path:
1.
Attach one end of an Ethernet cable to the network connector or standard
NIC in the Host PC.
Attach the other end of the Ethernet cable to one of the ports on the standard
network switch on the subnet used for system administration.
2.
Attach one end of an Ethernet cable to one of the ports on the same network
switch or subnet used for system administration.
Attach the other end of the Ethernet cable to one of the Gigabit ports on the
back of the Vess A3340s/A3340d
.
If you have multiple Vess A3340s/A3340d
systems, Host PCs or Servers, re-
peat steps 1 and 2 as required.
3. Follow the instructions for connecting to, and configuring the basic settings of
the Vess A3340s/A3340d.
Please note that you do not need to establish a network connection for the
initial setup. The web-based management interface is accessible using a
keyboard and monitor directly attached to the device. See the next section for
instructions.
Gigabit ports on the rear panel
Promise Technology
2
Quick Installation Guide