Task 5: Initial Setup
9
Task 5: Initial Setup
VTrak Default Network Settings
You must change these network settings so the VTrak works on your network.
The setting change requires a serial connection from your computer to the VTrak.
Your computer activates the Command Line Interface (CLI) on the VTrak to make
the required changes.
Setting up a Serial Connection
There are two methods to make the initial network settings:
•
Xserve Server
– Requires ZTerm software
•
Mac Pro
– Requires ZTerm software and USB-to-DB9 adapter
Xserve Server
Before you begin:
1.
Go to
http://homepage.mac.com/dalverson/zterm/
and download the ZTerm
terminal emulation software.
Install ZTerm onto your Xserve server.
2.
Find the RJ11-to-DB9 serial cable that ships with the VTrak.
Attach the RJ11 end of the serial cable to the RJ11 serial connector on one
of the VTrak controller modules. See Figure 3.
Attach the DB9 end of the serial cable to the serial connector on the Xserve.
Figure 7. Xserve Server serial connector
Component
Default Setting
Virtual Management Port IP address
10.0.0.1
RAID Controller 1 IP address
10.0.0.2
RAID Controller 2 IP address
10.0.0.3
Subnet Mask
255.0.0.0
1
2
DB-9 serial connector
Xserve Server
Summary of Contents for E610f
Page 18: ...VTrak Quick Start Guide 18...
