Task 5: Initial Setup
11
Attach the DB9 end of the serial cable to the DB9 connector on the USB-to-
DB9 adapter. See Figure 8.
Attach the USB end of the USB-to-DB9 adapter to a USB port on the Mac
Pro.
To set up a serial connection with VTrak:
1.
On your Mac Pro, double-click the ZTerm desktop icon (right).
The Local window opens on the desktop.
2.
From the ZTerm dropdown menus, choose
Settings > Connection
.
Set the Data Rate to
115200
and click the
OK
button.
3.
Press Enter once to launch the CLI.
The CLI opens in the Local window. The prompt should look like this:
administrator@cli>
If you see a Login prompt, type
administrator
and press Enter.
Then at the Password prompt, type
password
and press Enter.
4.
Go to “Making Settings on VTrak,” below.
Making Settings on VTrak
1.
Type the following string to set the system date and time, then press Enter.
administrator@cli>
date -a mod -d 2008/07/25 -t 14:50:05
In the above example, the date and time are included as examples only.
Use yyyyy/mm/dd for the date and a 24-hour clock for the time.
2.
Type the following string to set the Virtual Management Port IP address and
other settings, then press Enter.
administrator@cli>
net -a mod -t mgmt -s "dhcp=enable"
3.
To verify the settings, type
net
and press Enter.
administrator@cli>
net
===========================================
CId Port Type
IP
Mask
Gateway
Link
===========================================
1 1
Mgmt 192.168.10.85 255.255.255.0 192.168.10.1 Up
Note that the IP address described above belongs to the VTrak subsystem,
not to one of the RAID controllers.
The IP address and subnet mask shown here are examples only.
Summary of Contents for E610f
Page 18: ...VTrak Quick Start Guide 18...
