CAUTION!
Warning of feed chemical spraying around
Feed chemical can spray out of the hydraulic com‐
ponents if they are manipulated or opened due to
pressure in the liquid end and adjacent parts of the
system.
– Disconnect the pump from the mains power
supply and ensure that it cannot be switched
on again by unauthorised persons.
– Depressurise the system before commencing
any work on hydraulic parts.
CAUTION!
Danger of damage to the device
The device may be damaged by incorrect and
improper storage and transport.
– Take into account the information in the
"Storage, transport and unpacking" chapter if
the system is decommissioned for a temporary
period.
1.
Disconnect the pump from the mains/power supply,
2.
Depressurise and bleed the hydraulic system around the
pump.
3.
Flush the liquid end with a suitable medium - observe the
material safety data sheet! Flush the dosing head thoroughly
when using hazardous feed chemicals!
4.
Drain the gear oil - refer to the chapter entitled "Mainte‐
nance".
5.
Thoroughly clean the liquid end and the housing of chemicals
and dirt.
6.
Possible additional work - refer to the "Storage, transport and
unpacking” chapter.
In addition:
1.
Plug the caps on the valves.
2.
Push the caps onto the hose nozzles.
3.
Preferably place the pump on a pallet.
4.
Cover the pump with a tarpaulin cover - allowing rear ventila‐
tion!
5.
Store the pump in a dry, sealed place in line with the storage
conditions outlined in the chapter entitled "Storage, Transport
and Unpacking".
Final decommissioning
Temporary decommissioning
Decommissioning and disposal
71
