Scope of Supply
Page 20 of 102
6.1 Scope of supply
The following components are included as standard:
Description
Quantity
Controller AGIb
1
Assembly material, complete
2
Operating Manuals on Flash Drive
1
General safety notes
1
6.2 Mechanical
installation
6.2.1 Wall
mounting
Mounting materials (contained in the scope of
supply)
–
1 x wall bracket
–
4 x PT screws 5 x 35 mm
–
4 x washers 5.3
–
4 x wall anchors Ø 8 mm, plastic
Wall mounting
1. Remove the wall bracket from the housing
2. Press the two snap hooks (1) outwards
B
The wall bracket snaps slightly downwards.
3. Push the wall bracket downwards (2) to clear the
housing and tilt it out (3)
4. Use the wall bracket as a drilling template to
mark the positions of 4 drill holes.
5. Drill the holes: Ø
8mm (5/16”), depth = 50mm
(1.96”)
1. Screw the wall bracket into position using the
washers provided. If needed, use the wall
anchors provided.
2. Hook the bottom of the housing (1) into the wall
bracket
3. Lightly press the housing at the top (2) against
the wall bracket
4. Then check that the housing is hooked in at the
top and press down (3) until it clicks into place.
y
y
y
Figure 5 Attaching the wall Bracket
sing and tilt it out (3)
the wall bracket as a drilling template to
k the positions of 4 drill holes.
the holes: Ø
8mm (5/16”), depth = 50mm
6”)
Ï
Figure 7 Mounting the Wall Bracket
Å
Figure 6 Removing the wall Bracket