6
ASSEMBLY INSTRUCTIONS
Black (hot)
White (neutral)
Bare/Green
(ground)
Black
Blue
Whit
e
Green
WARNING:
Do NOT
wire the fan motor to a
variable-speed (dimmer)
wall control.
5
Downrod Clip
8
7
6
Canopy
Motor
Downrod Pin
Set Screw
Downrod
Yoke Cover
Yoke Cover
Yoke
Downrod
5. Feed the wires coming from the yoke through the yoke
cover, canopy, and downrod.
6. Insert the downrod into the yoke and reinstall the
downrod pin and downrod clip. Then retighten the two
set screws.
Note:
With wiring extending out of the downrod,
measure 8 inches of lead wire and cut the excess wire
with wire cutters (not included). Then strip 1/2” of
insulation from the end of each wire.
Tab
Slot
Downrod
Wire Connector
Mounting
Bracket
7. Lift the downrod into the mounting bracket. Rotate the
downrod until the tab in the mounting bracket is seated in
the slot in the downrod ball.
WARNING:
The fan and/or downrod should not rotate in
the mounting bracket if installed correctly. Failure to align
the slot in the downrod ball with the tab may result in fan
falling causing serious injury or death.
8. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the green wire from the downrod and mounting
bracket to the bare/green (ground) supply wire.
• Connect the white wire from the fan to the white
(neutral/common) supply wire.
• Connect the black and blue wires from the fan to the
black (live/hot) supply wire.
Note:
If there is a second hot/power wire coming from the
outlet box, connect it to the Blue (light power) fan wire for
separate light and fan control.
Important:
After the connections have been made, the
connected wires should be turned upward and pushed
carefully up into the outlet box. Place the black and white
wire connections on opposite sides of the outlet box.
Summary of Contents for Liva 51016
Page 1: ......