D
ISPLAY
G
UIDE
P
ROGRAM
S
ELECTION
...
60
When the unit is switched on, all readouts are active for a short ti-
me before the unit switches to standby (wait) mode.
Preset programs P-01 to P-11 and memory function
1.
Press the “ON/OFF” button to switch on the unit.
2.
Keep pressing the “Program” button until one of the preset pro-
grams (P-01 to P-11) is shown on the display.
3.
Press the “Set” button. The time will flash on the display, “ ´ “
for minutes and “ `` “ for seconds. Use the “+” or “–“ buttons
to enter the desired treatment duration (20 minutes to 2 hours)
in steps of ten minutes.
4.
Press the “Select” button 2 times. The intensity display “CH1”
will start to flash. Use the “+” or “–“ buttons to enter the desi-
red value (from 1 to 50). Press the “Select” button once more.
The intensity display “CH2” will start to flash. Once again, use
the “+” or “–“ buttons to set the desired value.
5.
To begin treatment, press the “Select” button once more. The
clock symbol at the top right of the display will start to flash.
Program display
Frequency display
Pulse width
display
Intensity,
channel 1
Intensity,
channel 2
Treatment time
Pause
Function check
manual_emt-4_270607 27.06.2007 14:44 Uhr Seite 60
