Page 18
•
Check if the Connection-LED (the top LED
on the Patch connector) turns green, to
indicate that the Patch is well connected
(see Figure 20).
If the Patch connector is not correctly
attached to the Patch or if the electrodes
do not make proper contact to the patient’s
skin, the Connection-LED will blink orange.
In that case, check the Patch connector
and/or press electrodes firmly to the
patient’s skin for contact. Repeat until the
Connection-LED turns green.
Also, the monitor indicates if the Patch
connector is well attached (see Figure 21.)
Please note!
In case of repeated mal
connection, remove the DeltaScan Patch
from the patient’s head.
Then start again at step 3: re-prepare the
skin and apply a new Patch to the patient.
Then reattach the Patch connector, until
the Connection-LED turns green.
Please note!
It may require a little force to
insert the DeltaScan Patch into the Patch
connector.
Please note!
Ensure the Patch connector cable
is free and not entangled with the Recording
button cable or anything else.
The preparation is now completed,
and a measurement can be taken.
Figure 21: Monitor screen when Patch and
electrodes are well connected.
Figure 20: The Connection-LED is green if the
DeltaScan Patch is well connected.
