Progressive Turf Equipment TDR-X, Operator'S Manual & Parts List

Page: 14 / 75

TDR-X
Operator’s Manual
12
•
Do not support the machine on cinder blocks, hollow tiles or other
members that may fail under continuous load.
•
Never perform service on a machine that is supported solely by
a jack. Always ensure proper blocking is placed to support load
during service.
WELDING / GRINDING WORK PRECAUTIONS
IMPORTANT! A fire extinguisher should be easily accessible during all welding work.
Welding repairs are to be performed by a trained welder with proper
service instructions. Know the material to be welded and select the
correct welding procedure and materials (electrodes, rods, wire) that
will provide a weld metal strength equivalent to the parent material.
Move the machine to a clean, safe area before welding, grinding or
using a cutting torch on it. This type of work should only be done in a
clean area and not in places that contain combustible liquids, such as
fuel tanks, hydraulic pipes or similar.
Connect arc welder ground as close as possible to work area.
Work with extra care when welding, grinding or torch cutting near
flammable objects.
WORKING ON PAINTED SURFACES
Heated paint gives off poisonous gases. Therefore, paint must be
removed from an area with a radius of at least 4 in (10 cm) before
carrying out welding, grinding, or gas cutting. In addition to the health
hazard, the weld will be of inferior quality and strength if the paint is not
removed.
Methods and precautionary measures when removing paint:
Blasting
– use respiratory protective equipment and protective
goggles.
Paint remover or other chemicals
– use a portable air extractor,
respiratory protective equipment, and protective gloves.
Grinding
– use a portable air extractor, respiratory protective
equipment, and protective gloves and goggles.
WORKING ON GALVANIZED / PLATED SURFACES
Only qualified welders should attempt a weld repair on galvanized or
plated components. Proper pre-welding surface preparation is
required.
Always ensure proper ventilation, wear proper respiratory protective
equipment and avoid direct contact with smoke emitted from the
welding process.