REHATEAM s.r.l.—vicolo Negrelli
5
—
31038
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual VARIO CARBON 10
SERVICE MANUAL
SIDE GUARD
After any adjustment of the rear wheel, you will have to adjust the position of the side
guard accordingly. You should adjust the side guard at approximately 5 mm from the
tyre. It is fixed to the frame in two points: to the backrest tube with a ring
A
that can slide
along the same tube; to the plate of support
B
.
If the side guard is straight, you can decide to modify it or not.
A
When you decrease the rear height
, you have to move the side guard up.
1. After the rear height adjustment, remove the bolt and nut
C1 C2
.
2. Loosen the bolt
D
, slide the side guard upward even beyond the necessary and tem-
porarily fix it just enough to let it stay where you position it. Should you need to go
beyond the bolt/washer/nut
X
that fixes the backrest tube, remove that bolt, slide the
ring over the hole and fix the bolt/washer/nut.
3. Put the rear wheel on and position the side guard at approximately 5 mm from the
tyre and parallel to it. Remove the rear wheel, fix the bolt
D
and put the rear wheel
back on.
4. While keeping the side guard at 5 mm from the tyre, from the outside of the plate of
support
B
, mark the point where you will have to drill a new hole (however, check
whether you can use the same hole).
5. To do so, use a pointed tool and let it through the slot of the plate. It is advisable to
mark it in the middle of the slot. If the rear height adjustment is remarkable, you may
need a new side guard.
6. Drill a 5 mm hole on the mud guard where just marked.
7. Countersink the hole.
8. Insert the bolt, washer and nut
C1 C2
and fix the side guard.
9. Adjust the brake.
B
When you increase the rear height
, you have to move the side guard down.
1. After the rear height adjustment, remove the bolt and nut
C1 C2
.
2. Lean the side guard on the outside of the plate of support.
3. Loosen the bolt
D
just enough to move the side guard, put the rear wheel on and
position the side guard at approximately 5 mm from the tyre. Remove the rear wheel
and fix the bolt
D
.
4. Draw a line on the lower side of the side guard considering that, when finally assem-
bled, it will lean on the spacer of the plate of support. The side guard cannot go
down beyond that spacer.
5. Remove the bolt
D
and remove the side guard.
6. Saw the side guard along the line you have just drawn and round off the edge with a
blade of a scissor or with fine sand paper.
7. Assemble the side guard and slightly fix it with the bolt
D
.
8. Continue following the points 3 to 9 of the adjustment
A
.
Follows next page
A
B
C2
A
D
C1
B
D
X
