progeo VARIO CARBON, Service Manual

Page: 7 / 30

REHATEAM s.r.l.—vicolo Negrelli 5 — 31038 Castagnole di Paese TV - www.rehateamprogeo.com
Service Manual VARIO CARBON 7
SERVICE MANUAL
DIRECTIONALITY
For the adjustment of the fork angle,
see chapters “fork angle”.
ADJUSTING THE DIRECTION-
ALITY
Loosen all four grab screws G , remove the bolt F and slide off the fork complete with
the axle P .
The axle has two side hollows B where you have to cast the flat inserts C0 or the 1°
titled inserts C1 that are recognizable thanks to two dots.
With the flat inserts C0 , the axle keep its original inclination.
With the tilted inserts C1 , the axle tilts by 1° right or left according to how to cast them
in the hollows — see images.
Note: you can cast the inserts only as indicated in these images.
Mounting back the fork: once you have casted the inserts C0 or C2 , it is advisable to
try to screw the bolt F to check there is no difficulty. Sometimes, in fact, the holes of
the inserts may have working burr that make the bolt hard to go through.
To mount the fork unit. Insert the axle P in the fork support paying attention to the
orientation of the same axle. In fact, the axle is not straight, but it shows a bend.
Such bend must be facing to the rear of the wheelchair.
Insert and screw the bolt F without tightening it much (it is enough to screw it up to
stop).
Adjust the fork angle — see sheet “fork angle 4”.
Note.
This type of adjustment can take place even at original assembly, therefore, you may
find the inserts
C0 on one axle and C1 on the other, for instance.
The wheelchair is not supplied with supplementary inserts, therefore, it will be neces-
sary to order them when needed.
B
P
0°
X Y 1°
Y X X Y
X Y Y X
0° 1° 1°
P P P
C0
C1
G1
G3
G2
G4
F
P
C0 o C1
C0 o C1
SIDE VIEW
P
REAR FRONT.
C0 o C1
F