3. Right and Left Bolts for Right and Left Cranks Installation:
It is important that you first read and understand the procedures before installing the
bolts to the cranks. Left bolt and left nylon nut are reverse threaded and the correct
direction to tighten is by turning to the
left
(counterclockwise).
If not done correctly,
the bolts and/or cranks may be damaged or stripped.
Step I:
Insert the Right Bolt for Right Crank (21) and Wave Washer (22) through the
right side of the Right Foot Bar (17). Align the right foot bar with the Right Crank (26)
so that they are
perfectly center.
Screw the Right Bolt for Right Crank (21) through
the crank by turning right (clockwise) by hand until it stops. Put a Spring Washer (27)
and screw the Nylon Nut (28) by turning right onto the bolt by hand until it stops. Use
one flat wrench to secure the nylon nut and S10 Allen Wrench to tighten the bolt
through the nylon nut until firm. For correct tightness, the bolt’s threads
MUST
protrude out through the nylon nut until no longer turns. Proper tightness is extremely
important to prevent parts from coming loose or damage during use.
Step J:
Repeat this procedure for the left side assembly and note that left bolt and left
nylon nut are tighten by turning to the
LEFT
(counterclockwise).
Step K:
Cover both Nylon Nuts (28, 87) with two Nut Caps (97).
11
ASSEMBLY
CORRECT
INCORRECT
INCORRECT
Note:
In order to install the bolt properly, keep it perfectly
straight when the bolt goes through the foot bar and the
crank. If the bolt is connected to the crank at an angle,
damage to the bolt and/or the crank may occur.
Please make sure the right bolt is for the right crank only
and the left bolt is for the left crank only. If done
incorrectly, the bolts and/or cranks may be damaged or
stripped.
Important:
Installing right bolt into right
crank can only be done by
turning right (clockwise).
R for right bolt
Tools:
S10 Allen Wrench
27
27
28
28
97
97
21
21
22
22
17
17
8
26
26
59
K
I
L for left bolt
Important:
Installing left bolt into left
crank can only be done
by turning left
(counterclockwise).
Open-Ended Flat Wrench
22
22
64
64
76
76
97
97
87
87
27
27
8
75
75
59
59
J
K
