1. Front/Rear Stabilizers and Adjustable Levelers Installation:
Step A:
Align the Front Stabilizer (54) onto the front curve of the Mainframe (59).
Make sure the arrow is pointing
UP
on the front stabilizer and that the Transport
Wheels (93) position toward the front and parallel off the floor. Attach two Bolts (52)
and on the other ends of bolts with two Curve Washers (55) and two Cap Nuts (56).
Using the flat wrench, tighten the cap nuts until firm.
Step B:
Align and attach the Rear Stabilizer (62) onto the rear curve of the Mainframe
(59) with two Bolts (52) and the other ends with two Curve Washers (55) and two Cap
Nuts (56). Using the flat wrench, tighten the cap nuts until firm.
Step C:
Remove the Nut (58) from the Adjustable Leveler (57). Screw the levelers
onto the bottom of the Mainframe (59) and hand-tighten the nut to the leveler.
Repeat for the other side.
Note:
Finish assembling the elliptical first and then refer to
page 20 on adjusting the levelers as needed.
IMPORTANT: To prevent Elliptical from wobbling, make sure you adjust the
levelers as instructed on Page 20.
Hardware:
9
ASSEMBLY
(52)
Bolt
4
PCS
(55) Curve Washer
4 PCS
(56) Cap Nut
4 PCS
Rear Stabilizer
Hardware (Step B)
Front Stabilizer
Hardware (Step A)
(Step C)
(57) Adjustable Leveler
2 PCS
(58)
Bolt
2
PCS
B
C
A
Tool:
Open-Ended Flat Wrench
52
52
56
56
55
55
56
56
55
55
52
52
57
57
58
58
55
55
56
56
52
52
52
52
62
62
59
59
54
54
93
93
