2. Handrails, Foot Bars and Rotation Rod Installation:
Step D:
Attach the Right Foot Bar (17) onto the bottom end of the Right Handrail (9)
with one Bolt (11) and one Nylon Nut (14).
Note:
Make sure the right foot bar is angled downward for correct installation.
Use one flat wrench to secure the bolt and the other flat wrench to tighten the nylon
nut until firm. For correct tightness, the bolt’s threads
MUST
protrude out through the
nylon nut until no longer turns.
Step E:
Repeat step above for the left side.
Step F:
Cover both Bolts (11) and Nylon Nuts (14) with four Nut Caps (88).
Step G:
Using S6 Allen Wrench, remove two Bolts (5), two Spring Washers (6), two
Washers (7), and two Wave Washers (22) PRE-ASSEMBLED from both ends of the
Rotation Rod (60).
Insert the Rotation Rod (60) into the hole on top of the Mainframe (59). Slide the
Right Handrail (9) onto the Rotation Rod (60) and secure in place with one set of the
above hardware that was removed. Use one S6 Allen Wrench to secure the bolt on
one end of the rod and the other S6 Allen Wrench to the bolt on the other end of the
rod to tighten the bolts until firm.
Step H:
Repeat step above for the left side.
Hardware:
10
ASSEMBLY
(Step D&E)
(11)
Bolt
2
PCS
(14) Nylon Nut
2 PCS
60
60
76
76
77
77
5
6
7
8
9
88
88 1111
14
14
88
88
17
17
59
59
22
22
22
22
11
11
88
88
14
14
88
88
8
5
6
7
E
H
Open-Ended Flat Wrench
F
D
G
Tools:
S6 Allen Wrench
S6 Allen Wrench with
Phillips Screwdriver
