2. Handrails, Foot Bars and Rotation Rod Installation:
Step D:
Using two flat wrenches, remove M10 Bolt (11), Washer (13) and M10 Nylon
Nut (14) PRE-ASSEMBLED to the end of the Right Foot Bar (17R).
Attach the Right Foot Bar (17R) onto the bottom end of the Right Handrail (9) with the
above hardware that were removed.
Note:
Make sure the right foot bar is angled downward for correct installation.
Use one flat wrench to secure the bolt and the other flat wrench to tighten the nylon
nut until firm. For correct tightness, the bolt’s threads
MUST
protrude out through the
nylon nut until no longer turns.
Step E:
Repeat step above for the left side.
Step F:
Cover both Bolts (11) and Nylon Nuts (14) with four M10 Nut Caps (88).
Step G:
Using #6 Allen Wrench, remove two Bolts (5), two Spring Washers (6) and
two Washers (7) PRE-ASSEMBLED from both ends of the Rotation Rod (60).
Insert the Rotation Rod (60) into the hole on top of the Mainframe (59). Slide the
Right Handrail (9) onto the Rotation Rod (60) and secure in place with one set of the
above hardware that was removed. Use one #6 Allen Wrench to secure the bolt on
one end of the rod and the other #6 Allen Wrench to the bolt on the other end of the
rod to tighten the bolts until firm.
Step H:
Repeat step above for the left side.
10
ASSEMBLY
Tools:
#6 Allen Wrench
#6 Allen Wrench with
Phillips Screwdriver
E
D
G
H
Open-Ended Flat Wrench
F
60
5
6
7
76
88
14
13
77
11
88
5
6
7
8
8
9
88
11
13
14
88
59
