PROBLEM SOLUTION
The computer will not power up.
1. Check that the batteries are inserted
properly with the correct polarity (see
marking inside the battery compartment).
2. Check that the battery springs are in
proper contact with batteries.
3. Remove the old batteries and replace with
the new batteries.
There is no readings on the computer
display
1. Check that the Sensor Wire (78) coming
out from the Mainframe (59) is securely
connected to the Extension Sensor Wire
(10) coming from the bottom of the Hand
Pulse Handlebar Support Frame (41). See
Step 4 page 13.
2. Check that the Extension Sensor Wire (10)
coming out from the top side of the Hand
Pulse Handlebar Support Frame (41) is
securely connected to the wire with a male
connector coming out from the Computer
(29). See Step 6 page 16.
3. Check that the two Hand Pulse Sensor
Wires (35) from the handlebars are
connected to the two wires with female
connectors coming out from the Computer
(29). See Step 6 page 16.
The elliptical makes a squeaking
noise.
1. The bolts may be loose on the elliptical,
please inspect and tighten any loose
bolts.
2. See page for lubrication.
Clicking Noise.
After prolong use, the chain may get loose and
start to have a clicking noise. Open the Right
& Left Cover (83, 84) to reach the Nut M6 (48).
Tighten the chain by turning the Nut M6 (48)
clockwise. Repeat for the other side.
TROUBLESHOOTING
22
