ProFurl NDE 42, Installation Manual

Page: 6 / 22

MODIFICATION OF THE FORESTAY
You should check, modify or change your forestay to have an eye at
the bottom of your turnbuckle.
Fit the PROFURL toggle (47) supplied between the bottom eye of the
forestay and the toggle, fit the pin (48) supplied, without using any other
part in this assembly.
Check on your turnbuckle that dimensions M and diameter N are
smaller than the ones shown on headboard 1.
• Should the forestay be too short : add a toggle at the top of the stay,
or change for a new stay.
• Should the forestay be too long : shorten the wire and have a new
turnbuckle with an eye terminal swaged at the bottom end of the stay.
II - ORIGINAL FORESTAY WITH A TURNBUCKLE
III - ORIGINAL FORESTAY WITH AN EYE JAW TOGGLE
ADAPTATION OF THE STAY
You should remove the captive pin to have an eye terminal.
The PROFURL toggle supplied should be fitted between the eye and
the chainplate, with no other fitting inserted in between.
IV - FITTING ON A ROD STAY
Please contact PROFURL.
6
M
N
Models
NDE/NDH 42
Stay diam. maxi
12,7mm (1/2”)
NDE/NDH 52
Stay diam. maxi
16 mm (5/8”)
Ø N maxi
40 mm
1
9/16
”
50 mm
2”
Without turnbuckle
cylinder
383 mm
1’ 3
1/16
”
M maxi
With turnbuckle
cylinder
723 mm
2’ 4
7/16
”
730 mm
2’ 4
3/4
”
Headboard 1