Prodeco Technologies G Plus Mariner 7, User Manual

Page: 34 / 42

34
To remove the battery, follow these instructions:

Locate the key ignition on the battery base and turn the key in a counter clockwise rotation to the
“UNLOCK” position. You must push the key in to turn from the “OFF” position to the “UNLOCK”
position. This position locks the latching pin into the battery, allowing the battery to be removed.

Grab the handle at the back of battery and gently pull towards the back of the bicycle to slide off.

The battery is now transportable and can be charged away from the bicycle. Do not carry battery by the
handle. Carry the battery by holding the battery.
c. Installing and latching the battery
The battery will latch in place and the key can be removed in the battery base ignition when the key is in the “OFF”
position. (SEE PHOTOS BELOW)
To install and latch the battery, follow these instructions:

Align the bottom of the battery with the battery base rail.

Once aligned, slide the battery completely into the battery base and until the battery base terminals
insert into the battery’s terminal outlet.

Once the battery is properly slid into place, you can then turn the key to the “ON” position.

The LEDs on the throttle in the “ON” position will display a charged battery if all 3 LED lights are on.
d. Charging the battery
The battery can be charged on the bicycle or off the bicycle. If charging the battery on the bicycle, the keys should
be in the “OFF” position. (SEE PHOTOS ON NEXT PAGE FOR CHARGING)
To charge the battery, follow these instructions:

Lift the handle up of the battery to expose the battery’s RCA charging input.

Insert the charging plug from the charger into the battery’s RCA charging input.

Insert the charger’s power cord into a wall outlet.

The charger’s LED light will light RED while the charger is charging the battery.

The charger’s LED light will light GREEN upon the battery being fully charged.