Prodeco Technologies G Plus Mariner 7, User Manual, Page: 22 / 42

22
f. Suspension fork adjustment
The G Plus Mariner 7 uses a dual
pre-load adjustable suspension fork.
The fork’s dual adjustment offers
either a softer of firmer ride for
smoothing out the bumps in your
path. The pre-load can be adjusted
according to your weight and liking.
You can easily adjust the suspension
performance by rotating the knobs at
the top of each leg at the crown.
Chapter 6: Tire, Tube, Wheel and Axle Repair
The G Plus Mariner 7 was designed for ease of servicing. Repairs are no more difficult than on a traditional bicycle.
Any neighborhood bicycle shop should be able to repair a flat, change a tire or replace a wheel. Please review the
following chapter on how to remove and replace the front and rear wheel of your G Plus Mariner 7.
a. Removing the front motor wheel
The front motorized wheel incorporates a quick disconnect for removing the wheel. To remove the wheel, follow
these instructions, it will only take a few minutes (you will need to use an 18mm wrench and snips). Read the
instructions fully before first attempting to remove the wheel.

First, turn the key to UNLOCK at the ignition and remove the battery.

To work on bicycle, it may be easier to turn the bicycle upside down by placing blankets on the ground
and resting the bicycle on the saddle and handlebar.

Locate the motor disconnect weather proof plug on the left side of the suspension fork and separate
the connector.

Locate the cable tie which ties the motor wire to the fork. Cut the cable tie with snips.

On each axle nut there is a rubber nut protector, remove these protectors simply by pulling on them.
On the wired side of the axle, slide the rubber protector up the wire only a few inches.

Using the 18mm wrench, turn counter clockwise each axle nut until the axle washers are clear from the
fork.

Remove the wheel from the forks by pulling on the wheel.