B687
16
1. Inspect the area around Slot1, verify the position of four around-
sockets, and then locate the small protruding rectangular tab on the side
of Slot1 (see diagram).
2. Examine the CPU Retention and attachments. There are three sets of
attachments: 1. The stand itself. 2. The CPU locking caps (two). 3.
The plastic screws (four).
3. Once the above two steps have been completed, slot the CPU Retention
into Slot1. Pull up the CPU stays on both side of the CPU Retention so
they are horizontal, at an angle of 90
°
. Then the side of the CPU
Retention with no mark on it and the side of Slot1 with the small
rectangular tab should be on the same side.
