Seite 24
•
The end of the drawing area is defined by the two side parts of the collecting
device as shown on the picture below.
•
Set the drawing length using the touchscreen (refer to chapter 7.1.7
” on page 28). Set the drawing length to the maximum on
the touch screen to ensure the collecting device to lift the applicator rod
properly.
•
Lower the weight (7) until it sits on the applicator rod and holds it in place.
Hint: Place a piece of paper at the end of the substrate to absorb any excess
coating material.
•
Set the desired drawing speed on the touch screen (see chapter 7.1.6
•
Apply the desired quantity of coating material on the substrate in front of the
applicator rod.
•
Start the application procedure by tapping the arrow button
on the touch
screen.
6.2.2 Fixing unit for profile rods and wire-bar applicators
applicators
•
Place the profile rod or wire-bar applicator into the holding device (8).
•
Fix the optional fixing unit on the sides of the applicator rod as shown below:
6.3 Application with gap applicator
•
Make sure that the glass plate is mounted with its glass surface facing up.
Alternatively a precision-vacuumplate can also be used.
Set the start stop (1) as follows:
