Seite 6
2
Safety information
2.1 Symbols used
This note comprises instructions needed to follow directions, specifications,
proper working procedure and to avoid data loss, damage or destruction of
the instrument.
This note signifies a warning about dangers to life and limb if the apparatus
is handled improperly. Observe these notes and be particularly careful in
these cases. Also inform other users on all safety notes. Besides the notes
in this instruction manual the generally applicable safety instructions and
regulations for prevention of accidents must be observed.
2.2 Safety notes and hints
It is strictly forbidden to open the housing of the Proceq ZAA 2600. If not
observed, all the guarantee and liability claims to Proceq SA will be void.
Place the device on a solid, even surface before operation.
Ensure that the separator (power socket) is accessible and that the
instrument can be separated from the power supply at any time.
Never touch any moving parts during operation.
The side panels must always be mounted during operation.
Always wear safety glasses during operation.
Only connect the Proceq ZAA 2600 to alternating current of a voltage of 100
– 240 V at 50 to 60 Hz. The voltage must correspond to the information
given on the identification plate of the apparatus. The device may only be
connected to sockets with a protective earth conductor.
Never use a damaged power supply cable. Only use power cable with
protective earth conductor. Removable power cables must not be replaced
by an insufficiently rated power cable. Only use the power cables provided
by the manufacturer may be used.
Never touch the hot plate, always wait until the heating plate has cooled.
Only coating materials or products with a flash point >250 °C can be applied.
Materials with a combustion point <250 °C must not get in touch with the
heating plate.
Always unplug the power cable before assembling and/or converting the
unit.
The Automatic Film Applicator Proceq ZAA 2600 is constructed in
accordance with the state of the art and is safe in use. However, there is
always risk when the instrument is handled improperly or otherwise as
intended by the manufacturer.
Depending on the coating material used, the test may only be carried out in
a ventilated environment.
