Seite 22
Set the end stop (2) as follows:
•
Loosen the screw of the end stop (2).
•
Position the end stop (2) behind the desired drawing area and lock it with the
screw. (The end stop (2) has a safety function.)
•
Set the drawing length using the touchscreen (refer to chapter 7.1.7
•
Place the wire-bar or profile rod into the holding device (8).
•
Lower the weight (7) until it sits on the wire-bar / profile rod and holds it in
place.
Hint: Place a piece of paper at the end of your substrate to absorb any excess
coating material.
•
Set the desired drawing speed on the touchscreen (refer to chapter 7.1.6
“Setting the drawing speed” on page 28).
•
Apply the desired quantity of coating material on the substrate in front of the
applicator rod.
•
Start the drawing process by tapping the arrow
on the touchscreen.
The Proceq ZAA 2600 will now move the drawing unit (23) forward and draw a
uniform film on the substrate. The drawing unit (23) will automatically stop when it
reaches the end position defined on the touchscreen.
•
Lift the weight (7) and hinge it into the top position (6).
•
Remove and clean the applicator rod.
•
Move the drawing unit (23) back to the initial position by tapping on
on
the touchscreen. The drawing unit (23) moves back either to 0 mm position or
to the start stop (1).
•
Remove the substrate.
Should the applicator rod rotate during the application, use the optional fixing
unit for profile rods and wire-bar applicators (see chapter 6.2.2 on page 24).
6.2.1 Using the optional collecting device
