Procentec Atlas 101-800110, User Manual, Page: 29 / 58

© PROCENTEC
29/58
Information about the device itself: the Product ID, vendor name, software
and hardware version, order code and serial number. If two devices of the
same ID have been found, using different firmware versions, a warning is
displayed (see Figure 8).
Response time
The last, min and max ping response times are shown here.
Port load
• In: for each incoming/ingress port the last, min and max port load
is shown.
•
Out: for each outgoing/egress port the last, min and max port
load is shown.
• Warning: some devices report an incorrect link speed (e.g. 10
Mbps instead of 100 Mbps). Since the link speed is used to
calculate the load, the reported load can be incorrect. If the
reported load is very high, check the link speed.
9.8 Link details
By clicking on a link or line between devices an info panel will appear on the right-hand side. Depending on the
type of device, information is shown in groups:
Linked devices
Device name, MAC address and port number are shown for both sides of the connection.
Load
For each direction the last and max port load is shown in %.
Warning: some devices report an incorrect link speed (e.g. 10 Mbps instead of 100 Mbps). Since the link speed
is used to calculate the load, the reported load can be incorrect. If the reported load is very high, check the link
speed.
Link status
• General: the link speed is indicated (10Mbps/100Mbps/1Gbps) together with its operational state
(up/down);
• For each direction, in and out, the ‘discards’, and ‘errors’ are shown. Discards are the number of
telegrams which did not fit in the internal buffer (memory overload) and ‘errors’ are transmission or
CRC errors.
Warning: some devices can report an incorrect link speed (e.g. 10 Mbps instead of 100 Mbps). An indication
that this occurs is when two devices in a link report different link speeds. This is not possible in Ethernet
connections.
Figure 8 - Firmware deviation warning