9
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
8
Visit
www.probrite.com/install
for installation video tutorials and product support
Installation (continued)
3B
Remove the glass
globe and heat sink
from junction box
BB
A
C
4B
Installing the external junction box
Installation (continued)
(fig 1).
(fig 2b).
(fig 2a).
(fig 1).
(fig 2).
CC
B
B
Surface Conduit Mount
☐
Mark and drill two holes on the wall
surface as per the desired location for
fixing the cast junction box (B).
☐
Place the junction box gasket (CC)
between the cast junction box (B) and
the wall surface. (Fig. 2)
☐
Use suitable screws applicable to
the mounting surface and secure the
junction box (B) on the surface. (Fig. 2)
☐
Remove the wire guard (C) from the
heat sink (D) by loosening the locking
screw using the allen key (BB). (Fig. 1)
☐
Remove the globe (A) from the heat
sink (D) by unscrewing it. (Fig. 1)
☐
Remove the reflector from the heat sink
(D) by loosening two small screws on
top (Fig 2a).
☐
Remove the black rubber gasket.
☐
Remove the heat sink (D) from the wall
mounting arm (E) by removing the two
philips head screws on each side of the
heat sink as shown in Fig. 2b.
☐
Also remove the wall mounting arm
(E) from the cast junction box (B) by
removing the four screws using a philips
screwdriver. (Fig. 3)
D
B
(fig 3).
E
CAUTION:
DO NOT touch the LED and DO
NOT damage or soil the reflector inside the
heat sink.
Reflector
Gasket
Follow Instructions Below for Side-Entry Conduit Surface Mounting
NOTE:
To remove the junction box (A) ,first
remove the black rubber gasket inside the
heat sink and then unscrew the two screws
underneath
Screws
(Provided by
others)
Screws
(Provided by others)
