11
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
10
Visit
www.probrite.com/install
for installation video tutorials and product support
Conduit
Pipe
5B
Making the electrical
connections
BB
B
(fig 1).
Side Conduit Surface Mount
☐
Remove one conduit plug from the side
of the junction box (B) from the where
conduit will enter (Fig. 1).
☐
Screw the removed conduit plug into the
back hole of the junction box
☐
Pull the wires from the conduit entry
through the side conduit entry into the
junction box (B) and also thread fixture
leads wire through the mounting arm (E).
☐
Make wiring connections inside the
junction box (B) as per the instructions
given below.
E
Installation (continued)
Wiring instructions
☐
If necessary, strip 3/8" of insulation
from junction box or fixture (A) wires
(fig 2).
☐
Connect
fixture black wire to house
black wire
, the (+) line, and
fixture
white wire to house white wire
, the (-)
common by twisting the exposed wires
together and using the wire nuts (AA).
Ensure no loose wires.
☐
Connect
house ground wire to the
green fixture ground wire
, by twisting
the exposed wires together and using
the wire nuts (AA).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
(fig 2).
TIP:
Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.
6B
Mounting the light
fixture
☐
Fix the wall mount arm (E) on the cast
junction box (B) using the four screws
removed earlier. (Fig. 1)
☐
Replace the heat sink (D) to the wall
mount arm (E) by tightening the two
screws removed earlier, using the philips
screwdriver. (Fig. 2a)
☐
Replace the black rubber gasket and
then fix the reflector back on the
heat sink (D) using two small screws
removed earlier. (Fig. 2b).
☐
Replace the polycarbonate globe (A)
on the heat sink (D) by screwing it back
on. (Fig. 3)
☐
Screw the wire guard (C) over the glass
globe (A) and tighten the wire guard
locking screw using the allen key (BB).
(Fig. 3)
Surface Conduit Mount
(fig 1).
B
E
(fig 3).
BB
A
C
B
(fig 2b).
(fig 2a).
Installation (continued)
Reflector
Gasket
D
