Installation Using Surface Mount Bracket
Installation -
2
Drilling the Hole on the Ceiling
Fix the Main Body
Connect Wire the Cables,
Terminal Blocks
Detach the Protection Film
Fix the Surface Mount
Bracket
2
Drilling the Hole on the Ceiling
To pass cables through the ceiling, drill a hole (30mm
diameter) on the ceiling panel.
Fix the Surface Mount Bracket
Pass the cables to the ¾” pipe hole, and screw the surface
mount bracket to the ceiling.
Rubber Gasket
- Before installing the gasket, the hole in the center is
to be cut by knife when only necessary.
- When installing gasket, the protrusion of the gasket
should be matched with the groove joint of the bottom
of the surface mount bracket.
Connect Wire the Cables, Terminal Blocks
Connect the terminal blocks to the main body.
See the section 2 ‘Installation-Terminer Block’ for detail.
Fix the Main Body
Screw the main body to the surface mount bracket by
screwing 4 lock-up screws.
Detach the Protection Film
Detach the protection film from the dome cover.
2
1
3
5
4
2
1
5
3
4
Rubber Gasket