Operating instructions LITTY 4you
21
Figure 43: Central single hand push handle with
folding handle end completely folded away
The central single hand push handle with
a foldable handle section may only be used
once the handle end has locked into position in
one of the steps. You can tell it has locked into
position as the push button springs out and is
visible.
21.2 Push handles offset to the back
Adjusting the height of push handles offset to
the back is possible without tools using the
quick release. To
adjust
the height, the quick
release levers are opened and after completing
the adjustment, are closed again. The height
can be infinitely adjusted. We recommend
adjusting both push handles to the same
height.
Figure 44: Closed quick release
To
remove
the push handles, the M4 end stop
screws (AF 3 mm) need to be unscrewed and
the quick releases need to be opened.
Figure 45: End stop screws mounted at the bottom
of the push handles offset to the back
After every adjustment or after reattach-
ment following removal, check that the push
handles are firmly attached in position. If nec-
essary the tension can be adjusted by turning
the quick release lever clockwise until it
reaches the end stop. In addition to that, the
M4 end stop screws (AF 3 mm) need to have
been mounted again.
22 Storage
When being stored, the wheelchair should be
kept in a dry environment and covered up
where possible.
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
not be exposed to any aggressive environ-
mental influences (salt in particular).
23 Transport
Personnel transport of the wheelchair user
or other persons in the product in a motor ve-
hicle has not been tested by PRO ACTIV and
is therefore not approved. All vehicle occu-
pants must only sit on the seats installed in the
vehicle during the journey with the associated
restraint systems. Failing to observe this leads
to increased risk of injury for the user as well
as for third-parties.
The wheelchair can be fitted with a head-
rest. These headrest systems are not suitable
for use as headrests when being transported in
a motor vehicle.
M4 End stop screws