Operating instructions LITTY 4you
11
Figure 9: Illustration of terms
Figure 10: Serration on the foot bracket clamp, with
positive locking
To
adjust the length of the support tubes
,
the M6 fixing screws (AF 5mm) on the foot
bracket clamps have to be undone. The length
of the support tubes can then be adjusted.
Figure 11: Fixing screws on the foot bracket clamps
If the
angle of the support tubes
is to be
changed, then the M6 fixing screws (AF 5 mm)
need to be loosened further so that the positive
locking on the interlocking serration is re-
leased. Now the angle of the support tubes can
be adjusted.
Once you have finished adjusting the angle
and the length, tighten the M6 fixing screws
(AF 5 mm) again using 7 Nm tightening torque.
Figure 12: Serration on foot bracket clamps, positive
locking undone
The
angle
of the
foot plate
can also be ad-
justed by loosening the M6 clamp screws (AF
5 mm) on the bottom of the foot rest. Once the
adjustment of the angle has been completed,
tighten the M6 clamp screws (AF 5 mm) with 7
Nm tightening torque. This tightening torque
should not be exceeded as higher tightening
torques can damage the clamp.
Figure 13: Foot rest from below
(Footrest)
support
tubes
Foot bracket
clamps
M6 fixing screw
M6 clamp screws
Foot rest
Interlocking serration
with positive locking
Interlocking serration with
positive lock released
Foot rest
support plate