NJ1 el. & FREAK el. compact bike usage instructions
26
Figure 43: Quick release lever opened for adjusting
the neck rest angle (view from behind)
After every adjustment, check that the
neck rest is firmly attached in its position. If
necessary the tension can be adjusted by turn-
ing the nut of the quick release lever clockwise
until it reaches the end stop.
Figure 44: Nut of the quick release lever
21 Collision guard
Figure 45: Collision guard
21.1 Collision guard mount
To remove the collision guard, both M6 fixing
screws (AF 4 mm) are undone on the right and
left inlet. Now the collision guard can be re-
moved from the inlet.
Figure 46: M6 fixing screws on the clamp on the
axle tube
21.2 Mounting the collision guard
Figure 47: Inlet of the collision guard with several
boreholes
For mounting the collision guard, the collision
guard is pushed onto both inlets. In doing so,
ensure for the correct position of the collision
guard on the inlet as there are several bore-
holes on the inlet. Then both M6 fixing screws
(AF 4 mm) are tightened to 7 Nm and secured
with thread lock fluid (Fig. 46).
Quick release lever
open
Nut of the quick
release lever
M6 fixing screw
Inlet