NJ1 el. & FREAK el. compact bike usage instructions
21
To prevent short-circuits due to moisture,
the protective cap must be placed on the sock-
et that does not have a magnetic connector.
When reconnecting the rechargeable
batteries, always switch the drive system off.
17.6 Drive system
The drive manufacturer's usage instructions
are included with the product as a supplement
to the supplied usage instructions. Operation of
the drive system is described there in detail.
Please observe the contents of these instruc-
tions. A summary of how to switch on and off
and how to attach and remove the display can
be found in the following subchapters.
17.6.1 Switching on and off
To
switch on
the drive system, briefly press
on the middle button (rhombus ) on the con-
troller.
Figure 27: controller button
To
switch off
the drive system, press the mid-
dle button (rhombus ) down for approx. 2
seconds while the start menu is displayed. By
pressing the arrow buttons (arrow down and
up ), navigate to "Switch off" and confirm
with the middle button
(rhombus ).
Automatic switch-off:
After 10 minutes with-
out use, the drive system switches off automat-
ically.
Do not switch off the drive system by
removing the display when it is switched on.
This could damage the electronics.
If the
rechargeable battery
has not been used
within 48 hours, it goes into “deep sleep mode”
and must be switched on by pressing the
“ON/OFF button” before switching on the dis-
play.
Figure 28: On and off button on the rechargeable
battery
17.6.2 Attaching and removing the display
To
attach the display
, place it on the dock,
rotated to the left at an angle of about 30°.
Rotate the display on the dock clockwise by
30°, applying light pressure, so that both com-
ponents are aligned. Now slide the display
holder over the display and dock, from above.
Figure 29: Attaching and removing the display
select / middle
button
down / bottom
arrow button
up / upper
arrow button
ON/OFF button
