3 Installation
The Hybrid Spot welder is inspected and tested prior to leaving the factory to
guarantee consistent quality and the highest possible reliability. Follow the instal-
lation tips and operating instructions below to ensure user safety and proper
welder performance.
WARNING!
Do not operate or place the welder near water, in wet
locations or outdoors. Risk for injuries or damage to the welder.
WARNING!
Do not place the welder on unstable or uneven
ground. The welder might fall causing personal injuries and damage to
the welder. Do not operate on a slope of more than 10º.
A grounded electrical plug must be installed (
refer to section 3.4 “Connection of
electrical supply”
).
Check the contents of the shipping container against the packing list, consign-
ment note, or other delivery documentation to verify that everything is included
and in the correct quantity. Check the Spot Welder carefully to make sure that
no damage has occurred during transport. If anything is damaged or missing, the
welder may be unsafe to use till the part is repaired or replaced. If anything is
missing, please contact your supplier. Remove all packaging material from the
welder.
For your convenience, the welder ships fully assembled.
Insert the support arm (boom) as shown in
Figure 3.1
Figure 3.1
IMPORTANT!
It is the responsibility of the owner to ensure that
the equipment has been installed as specified in the instructions pro-
vided. It is also the owner's responsibility to ensure that the welder
is inspected in accordance with applicable regulations before it is
put into service. Do not use for thawing out frozen water pipes (17.1)
ATTENTION!
Ne pas faire fonctionner le soudeur près de l'eau, en voie
humide ou à l'extérieur. Risque de blessures ou de dommages au soudeur.
ATTENTION!
Ne placez pas le soudeur sur un sol instable ou irrégulière.
Le soudeur peut tomber causant des dommages graves au soudeur.
Ne pas utiliser sur une pente de plus de 10º
IMPORTANT!
C'est la responsabilité du propriétaire de s'assurer que
l'équipement a été installé comme spécifié dans les instructions fournies.
C'est aussi la responsabilité du propriétaire de s’assurer que le soudeur est
inspecté conforment à la réglementation applicable avant qu'il ne soit mise
en service. Ne pas utiliser pour dégeler les conduites d'eau congelées (17.1)
Page 8
All Info Copyright © Pro Spot International Inc.
3.3 Welder assembly
3.2 Packaging and delivery inspection
3.1 General
3 Installation
9
Hybrid Spot
