All Info Copyright © Pro Spot International Inc.
Figure 4.3 The Hybrid Spot Control Panel
4 Operation
Page 12
4.3 Turning on the welder
4.2.3 Hybrid Spot Control Panel
120
190
300
350
ELECTRODE
PRESSURE
CHARGING
BAT 1
BAT 1
ON
ON
ON
ON
BAT 2
BAT 3
BAT 4
PUSH TO
TEST BATTERY
WELD
WELD
TIME
POWER
SERVICE
BAT 1
TEST
READY
ON
OFF
BAT 2
TEST
BAT 3
TEST
BAT 4
TEST
HYBRID SPOT
CHARGING
BAT 2
CHARGING
BAT 3
CHARGING
BAT 4
DC AMPS
DC AMPS
DC AMPS
DC AMPS
260
0
40
80
12
0
160
PHS-100
1.
Toggle the power switch on the front panel to “ON”.
3.
The System Display window will show the battery
voltage & charge current on all four batteries.
4.
The weld toggle switch must be in position “WELD” to perform welding
duties. Start with 3 batteries ON, (BAT 1, 2, 3 switches ON) and adjust
the weld time to 260-300. If more power is required, turn BAT 4 ON.
5.
Increase the WELD TIME knob if a longer weld time is needed. NOTE: An
increased weld time will drain the batteries quicker. Also, always clean and
sharpen weld electrodes to maintain welding performance.
2.
The Hybrid Spot is now ready to use.
IMPORTANT!
Make sure to read the instruction manual before operating
the welder. Only trained personnel should use this welder.
IMPORTANT!
Assurez-vous de lire le Mode d’Emploi avant d'opérer
le soudeur. Seul le personnel qualifié devrait utiliser ce soudeur.
Batt1
Batt2
Batt3
Batt4
15.30V
15.30V
15.30V
15.30V
1.5A
1.5A
1.5A
1.5A
14
Hybrid Spot
